A needle that waves is telling you something
A speedometer needle that flicks or wavers instead of sitting steady is almost always the cable, not the instrument. The inner cable is binding somewhere in its casing and winding up, then releasing.
The usual causes are a dry inner, a tight bend in the routing, or strands that have begun to break near the ferrule. A cable that squeals is the same fault a step further on.
Route it before you tighten it
Lay the cable along its run first and check every bend is gentle. A sharp bend is what kills the next cable as surely as it killed the last, and on this platform the run past the bell housing is where it usually happens.
Grease the inner lightly along its lower two thirds, leaving the top end dry so grease cannot migrate into the speedometer head. Make sure the inner seats into the drive square at both ends before the ferrules are tightened.
Questions about this part
What does the 052014 Speedo Cable fit?
It is listed for the CJ340. Quote your chassis number when you enquire so fitment can be checked.
How do I order the Speedo Cable?
Use the “Contact Nonu Ventures” button. Nonu Ventures is the exporter: send them the part number (052014), the quantity and your destination and they quote within 24 hours, shipping worldwide.
Is it a genuine part?
Nonu Ventures lists genuine OEM or export-grade components, cross-referenced to OEM catalogues and fitment-checked before dispatch.
Does the 052014 Speedo Cable also fit the Mahindra MM540?
Yes — Nonu Ventures lists it for the Mahindra MM540 as well. There is a separate Mahindra MM540 page for this part.
